黄色免费视频

  • Company news NEWS

    Your current location: home page > Company news >Changsha Buyuan medicine machine teaches you how to use three knife capping machine

    Changsha Buyuan medicine machine teaches you how to use three knife capping machine

    Release time: 2020-02-10 hits: 1123

    1. Put the bottle filled with liquid and cover on the lower tray, lean against the V-shaped support block, hold the bottle with one hand, and tighten the handle with the other hand backward and downward. At this time, the tray holds the bottle up until the bottle cap and the capping head are pressed tightly.
    2. After the bottle cap and the capping head are compressed, the three non-stop capping cutters are rotated for several turns, and then the lower edge of the bottle cap is rolled tightly. (note) the motor must run clockwise.
    3. Push the handle forward to make the cover of the rolled cap return to its original position with the tray. The whole operation process is completed. Repeat the above operation for each bottle cap rolling.
    How to adjust the upper arm when rolling bottles of different specifications
    The machine can be used to roll 5-500ml bottle caps. Multiple capping heads can be replaced. The upper capping heads can be selected according to different bottle caps. When using a bottle of any size, put the bottle on the tray, hold the cross arm with one hand, and loosen the nut on the left side of the cross arm with a 17 × 19 spanner with the other hand to make the cross arm drop or rise until the distance between the middle capping head and the top and bottom of the bottle cap is about 20 mm, tighten the nut, and then tighten the supporting ring with the inner hexagon wrench The supporting ring is locked. (note) when tightening, pay attention to the alignment between the capping head and the upper and lower position of the bottle cap.

    How to adjust the V-shaped support block
    Put the bottle into the lower V-shaped bracket, loosen the two screws on the support block, move the bottle and the lower V-block together until the bottle is adjusted to the center of the lower tray, tighten the two screws on the V-block, and then put a bottle with a bottle cap on it. If the capping head is not aligned with the top and bottom of the bottle cap, the left and right positions of the upper cross arm can be adjusted according to (1), such as capping When the front and rear positions of the head and the bottle cap are not aligned, loosen the two screws on the V-block and adjust the front and rear position of the V-block until the capping head and the bottle cap are aligned.
    1. What should I do if the cap is not tightly rolled?
    A: the locking nut of the capping head can be unscrewed, and the upper capping head can be turned out anticlockwise, and then the fixed nut can be locked.
    2. The bottle cap is rolled too tightly, how to deal with the phenomenon of peeling the bottle cap?
    Answer: the locking nut of the capping head can be unscrewed and turned into the capping head clockwise, and then the fixed nut can be locked.
    3. What should I do if the lower edge of the bottle cap is not tight?
    Answer: loosen the locking bolt of the rolling cutter head, and adjust the eccentricity of the three rolling heads according to the actual situation.