黄色免费视频

  • Technical articles ARTICLE

    Your current location: home page > Technical articles >The way of changing the cutter of small capping machine

    The way of changing the cutter of small capping machine

    Release time: June 26, 2019 hits: 695
        Small capping machine In the process of production and use, in the case of bad capping, poor capping and adjustment, check whether it is caused by the wear of rolling knife. If the rolling knife is worn, replace the three rolling knives at the same time.

    When rolling down the nut, use three knives to lock the nut. When replacing the new rolling knife, insert the handle of the new rolling knife into the upper tool bar, and gently bring it up with the nut, so as not to make the rolling knife fall off. Put on three rolling knives in turn.
     
    Hold the other two knives in the same way to make the bottle on the same plane. Next, you can start the machine and try rolling to see how the effect is. If you are not satisfied, you can fine tune the capping head.
     
    in use Small capping machine The bottle cap is not tight during production. Some customers can't find the reason for this situation. They think that the lid can be rolled tightly with a little force, so they pull the handle up and roll it hard. They don't know that not only can the bottle cover be rolled well, but also broken bottles may be produced under the impact of force.
     
    The solutions to this situation are as follows:
    1. If the cover is not tightly rolled, the locking nut of the rolling head can be unscrewed clockwise, and then the upper capping head can be turned out clockwise, and then the fixing nut can be locked.
    2. The cap is rolled too tightly, and the bottle cap is peeled. The lock nut of the upper rolling head can be unscrewed clockwise, and the upper rolling head can be screwed in the anti clockwise direction, and then the upper fixing nut can be locked.
    Do not rotate the capping head too much until it is adjusted.